GPC130CG【PDF 1/2 页】POWER SUPPLY SWITCHER 130W QUAD

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录227

[1页]2页

GPC130 Commercial/ GPM130 Medical

130 Watt Global Performance Switchers

FEATURES:

? Wide-range ac input 85-264 Vac

? 2-year warranty

? Commercial Approved to UL1950, IEC950,

EN60950 and CSA22.2-234 L3

? Medical Approved to UL2601-1, IEC601-1 and

CSA22.2 No. 601

? Conducted EMI exceeds FCC Class B and CISPR 22

Class B (Commercial models) and CISPR 11 Class B

(Medical models)

marked to LVD

SPECIFICATIONS:

Ac Input

85-264 Vac, 47-63 Hz single phase.

Input Current

Maximum input current at 120 Vac, 60 Hz with full rated output

Power Fail

TTL- or CMOS-compatible output goes low (< 0.5V) 5 ms

before output voltage drops more than 4% below nominal

voltage upon loss of ac power. The signal is factory set to

trip on 84 to 94Vac brown-out depending upon incoming line

impedance and distortion. Other settings are available to the

user through adjustment of built-in potentiometer.

load: 3.5 A

Output Noise

Hold-Up Time

20 ms minimum from loss of ac input at full load, nominal line

(115 Vac).

Output Power

100 W continuous, 165 W peak; 130 W with 26 cfm air flow. Peak

ratings are for 60 s maximum duration, 10% duty cycle. During

peak load condition, output regulation may exceed total

regulation limits.

Overload Protection

Fully protected against short circuit and output overload. Short

circuit protection is cycling type power limit on outputs 1 & 2;

foldback type on outputs 3 & 4. Recovery after fault is automatic.

See output ratings chart for additional notes or conditions.

Overvoltage Protection

Main outputs: 124% ± 12% typical.

Efficiency

70% at full rated load, nominal input voltage, depending on model

and load distribution.

Turn-on Time

Less than 1 second at 120 Vac, 25 ° C (inversely proportional to

input voltage and thermistor temperature).

0.5% rms, 1% pk-pk, 20 MHz bandwidth, differential mode.

Measured with noise probe directly across output terminals of

the power supply.

Transient Response

Main output — 500μSec typical response time for return to within

0.5% of final value for a 50% load step change. ? i/ ? t<0.2 A/μs.

Maximum voltage deviation is 3.5%. Startup/shutdown overshoot

less than 3%.

Remote Sense

Provided as a standard feature on output 1.

Voltage Adjustment

Built-in potentiometer adjusts voltage ±5% on outputs 1 & 2.

Overload Protection

Factory set to begin power limiting at approximately 170 W.

EMI/EMC Compliance

All models include built-in EMI filtering to meet the following

emissions requirements:

EMI SPECIFICATIONS COMPLIANCE LEVEL

Conducted Emissions GPC130 EN55022 Class B; FCC Class B

Conducted Emissions GPM130 EN55022 Class B; FCC Class B

Static Discharge EN61000-4-2, 6 kV contact, 8 kV air

RF Field Susceptibility EN61000-4-3, 3 V/meter

Input Protection

Fast Transients/Bursts

EN61000-4-4, 2 kV, 5 kHz

Internal ac fuse provided. Designed to blow only if a catastrophic

Surge Susceptibility EN61000-4-5, 1 kV diff., 2 kV com.

failure occurs in the unit.

Commercial Leakage Current

Inrush Current

Inrush is limited by internal thermistors. Inrush at 240 Vac under

cold start conditions will not exceed 34 A.

Temperature Coefficient

0.03%/ ° C typical on all outputs.

Thermal Shutdown

Provided as a standard feature. Designed to protect unit from

prolonged overtemperature.

Environmental

Designed for 0 to 50 ° C operation at full rated output power;

derate output current and total output power by 2.5% per ° C

above 50 ° C. See Environmental and Packaging Specifications

on next page.

0.7 mA 254 Vac @ 60 Hz input.

Commercial Safety

Approved to UL1950, CSA22.2 No. 234 Level 3, IEC950 and

EN60950. UL file #E135803 commercial; CSA #LR46516 all

models. The output(s) are intended for safety earthed Signal

Output and Intermediate Circuits only. All dc outputs are SELV

under normal and single fault conditions.

Medical Leakage Current

35 μA 254 Vac @ 60 Hz input.

Medical Safety

Approved to UL2601, CSA22.2 No. 601 Level 3 and IEC601. UL

file E116994; CSA #LR46516. The output(s) are intended for

safety earthed Signal Output and Intermediate Circuits only. The

output(s) are not acceptable for patient connection without

additional isolation. All dc outputs are SELV under normal and

single fault conditions.

Condor D.C. Power Supplies, Inc., 2311 Statham Parkway, Oxnard, CA 93033

800-235-5929 ? 805-486-4565 ? FAX 805-487-8911 ? www.condorpower.com

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式